Please select Into the mobile phone version | Continue to access the computer ver.
Tutorials

ROM Flash

There are two ways to flash — via PC and via TF card.


Flashing via PC


Kit 

·Type-C cable

·Flashing tool: AndroidTool (Version: v2.58 or higher)

·RK Driver Assistant: Driver Assitant



Step 1 Install Driver Assistant. 

Unzip DriverAssitant and run DriverInstall.exe; click "Install Driver".

image.png

Note: If you downloaded the older version of DriverAssitant before, please click "Uninstall Driver" first, then click "Install Driver".


Step 2 Make Station M1 be ready to be flashed.

Step 2-1 Utilize Type-C cable to connect Station M1 and PC (Type-C cable supports power supply and data connection).

 image.png

image.png

Step 2-2 Connect the Station PC to power. Open AndroidTool.exe on PC and “Found One ADB Device pops up. Click “Switch”, after switching, “Found One LOADER Device” pops up.

1.png

2.png



If it shows“No Devices Found”:

(1) Disconnect the Station M1 from power (unplug the Type-C cable).

(2) Insert the Allen wrench (following accessory) into the AV port (RECOVERY button is inside), keep holding the RECOVERY button.

(3) Connect the Type-C cable to Station M1 back. When “Found One LOADER Device” pops up, release the RECOVERY button.  

 m1.png

Note: If it still shows “No Devices Found”, check if the Driver is successfully installed.


Step 3 Flash ROM image to Station M1.

Step 3-1 Click “Upgrade Firmware”; click Firmware”; select the downloaded ROM image

image.png

image.png

                                         (Downloaded ROM image)


Step 3-2 Click “Upgrade” to flash. When it shows “Download Firmware Success”&“Reset Device Success”, the flashing is finished.

6.png



Flashing via TF Card


Kit


·TF card

·USB card reader

·Flashing tool: SD_Firmware_Tool 


Step 1 Flash ROM image to TF card.

(1) Insert the TF card into the USB card reader; insert the USB card reader to the PC.

(2) Open SD_Firmware_Tool and select the inserted TF card.

(3) Tick "Upgrade Firmware".

(4) Click "Firmware" and select the downloaded ROM image.

(5) Click "Create".  

123.png


(6) When the window shown below pops up, select “Yes”. 

1234.png


(7) When the window shown below pops up, the TF card flashing is finished.

12345.png


Step 2 Flash ROM image from TF card to Station M1.

(1) Insert the TF card to Station M1 and connect Station M1 to power.“Installing system update” progress bar will appear and after loading, the flashing is finished.

(2) Remove the TF card, and Station M1 will be automatically rebooted.

33.png